This sleeve is case hardened to increase wear resistance of the metal.
Fit to standard (flanged) axle shafts on all the tractors listed below.
Made in the UK as per original Nuffield specification.
This type of sleeve was introduced for the standard axle shaft on Nuffield 10/60 tractors from serial number 89157 and Nuffield 10/42 tractors from serial number 89757. If your tractor was manufactured before these change points or is fitted with a sliding hub axle you may require the earlier type sleeve (see part no. ATJ7056 SLEEVE).
View items 11 and 15 in the illustration.
Dimensions:
Outside diameter: 86 mm
Inside diameter: 70 mm
Length: 44 mm
(Check the length before ordering as this will indicate whether you need this later type sleeve or the earlier type sleeve).
Important note: This sleeve has to be preheated to fit and special care must be taken when fitting. We highly recommend you refer to the workshop manual or call our parts team for further information.
Fitted to tractors: